: A utility program used for setting up and testing Zebex scanners. Note that an RS-232 cable is typically required for setup, while the USB connection is primarily for firmware updates.
| Problem | Solution | |--------|----------| | Scanner beeps but no data appears | Switch to USB Keyboard Wedge mode; check that cursor is in an input field. | | Garbled or missing characters | Adjust intercharacter delay (scan a “slow” or “fast” keyboard barcode). | | Won’t read 2D codes | Enable 2D symbologies via config barcode or EZConfig. | | Virtual COM not working | Reinstall FTDI/SiLabs driver; assign a low COM port number (1–4). | | Scanner powers off randomly | Check USB cable; connect via powered USB hub if using long cables. | zebex z6170 driver 20 extra quality
If you are setting this up on Windows 10 or 11, here is the cleanest way to get it running without the bloat: : A utility program used for setting up
: Includes a trigger button to switch from omnidirectional to a single-line scan for targeted reading of barcodes in close proximity. | | Garbled or missing characters | Adjust
for standard USB HID keyboard emulation. While "20 extra quality" is not a recognized official software version, it likely refers to the scanner’s 20-line omnidirectional laser beam
: Available in black or white to suit aesthetically sensitive locations like boutiques or bookstores. It also features a unique suction cup base for secure counter mounting.
distributed across 5 directions, which allow for a scan rate of 1,400 scans per second Specification Scan Pattern 5 directions of scan field (20 lines total) 1,400 scans per second (omnidirectional) Light Source 650 nm visible laser diode (VLD) Keyboard Wedge, RS-232, HID USB, USB Virtual COM Depth of Field 0 – 300 mm (for 20 mil barcodes) Setup and Configuration To configure the scanner, you must use the Z-6170 User Manual Z-6170 Programming Guide : Scan the "Set" barcode in the manual. Choose Parameter
