Gyd-9e Datasheet Jun 2026

Are you planning to to LED, or are you troubleshooting a specific power issue with this board?

Enable signal. High level (approx. 3.3V) to turn on, low level (0V) to turn off. gyd-9e datasheet

Power a Raspberry Pi or Arduino from a 24V industrial PLC supply. Are you planning to to LED, or are

While rated for up to 30V, some users report excessive heating of the switching transistor at input voltages above 14V; using a step-down converter or a 78R12 regulator is a common community recommendation from RadioKot for higher voltage supplies. Are you planning to to LED

A: Yes. At 5 V, the input draws ~8 mA, well within the sink/source capability of most microcontrollers. No external transistor needed.

: Features two output ports to drive multiple LED light bars simultaneously without voltage fluctuations.